7. An Analysis on Fault Dimensions and Parameters  

Some quantitative results (right figure):
  Triangle plots (TP) are results of supplemental 
 experiments (see 8.Further study)

Thickness vs. Dip angle (upper)  
Clear positive correlation is appeared except 
         TP, however the dip angle must be limited and
         controlled by the Coulomb's law of friction.
   * Low angle of TP may be due to loose compaction 

Thickness vs. Fault intervals (lower)
The relation between thickness and 
        interval of faults is not so clear
        due to inhomogeneity of compaction,
        however a positive correlation might be
        estimated from our experience.